- Backing Crusher Parts
- Grouting Machinery
- Locking Bearings
- Setting Anchor Bolts
- Chocking of Machinery
Description
Method of Use
- Seal all crevices with putty (such as Megapoxy PF Rapid set putty) so that backing mixture does not leak out.
- Make certain no settling has occurred in the resin by stirring, then add the hardener (Part “B”) slowly with continual mixing.
- Using low speed electric drill, mix well, but do not aerate.
- Mix until uniform colour is obtained.
- The mixture must be used immediately after mixing.
- If ambient temperature is high, the kits should be stored in as cool a place as possible. High ambients will lead to greatly shortened usable life.
- If topping up is required, then this can be carried out at a later date when it is convenient.
- If adhesion is not required, one or both surfaces should be coated with wax or grease based release agent.
- Allow Megapoxy HICB to harden before returning crusher into service.