NDP-15FPT

specification

 

Nominal diameter		1/2 ″ (15A)
Material connection	Inlet	Rc1 / 2
	Discharge port
Air connection	Supply port	Rc1 / 4 (with air cock)
	exhaust port	Rc3 / 8 (with muffler) *
Service air pressure		0.2 to 0.7 MPa
Discharge pressure		0.7MPa
Discharge rate / cycle		70mL
Slurry limit (maximum passing particle diameter)		1mm or less
Mass		-15BA NDP: 4.1Kg NDP-15BS □: 6.3Kg NDP-15FP □: 3.5Kg NDP-15FVT: 4.3Kg

* The silencer is built into the pump body.
Rc3 / 8 screw holes are machined for connecting hoses to guide exhaust to ducts.

Since the NDP-15 series uses the DP-10 series diaphragm, select the NDP-20 series that is one size up for large-scale operation at 20L / min or higher. NDP-15BA □ series uses nylon (PA) as the material for the valve receiver. Pay attention to corrosion resistance. Not suitable for MEK etc.

 

Please download the parts exploded view and parts list from the data download page → Download data

Body (wetted part) material	Diaphragm material
	C: Chloroprene (CR)	N: Nitrilgam (NBR)	T: Fluorine resin (PTFE)	H: Polyester type thermoplastic elastomer (TPEE)	S: Polyolefin-based thermoplastic elastomer (TPO)
A: Aluminum alloy (ADC12)	NDP-15BAC (851946)	NDP-15BAN (851947)	NDP-15BAT (851945)	NDP-15BAH (851948)	NDP-15BAS (852680)
S: Stainless steel (SCS14)	NDP-15BSC (851958)	NDP-15BSN (851959)	NDP-15BST (851957)	NDP-15BSH (851960)	NDP-15BSS (852681)
P: Polypropylene (PPG)	NDP-15FPC (851903)	NDP-15FPN (851943)	NDP-15FPT (851698)	NDP-15FPH (851905)	NDP-15FPS (852683)
V: Polyolefin full oil (PVDF)	---	---	NDP-15FVT (852141)	---	---

Note) Clicking the model / product number will display the parts list and parts exploded view.
 

Main material

 

Model	NDP-15BA □	NDP-15BS	NDP-15FP	NDP-15FVT
Ball valve Flat valve	NDP-15FP □ / NDP-15FVT ・ ・ ・ PTFE Other NDP-15B □□ ・ ・ ・ Same as diaphragm material
Valve seat	A5056	SUS316	PPG	PVDF
Valve holder	PA
Center disc	A5056		PPG (SUS304 *)	PVDF (SUS304 *)

* SUS304 is insert material

★ Valve model
NDP-15BA □ / NDP-BS □ ・ ・ ・ Ball valve
NDP-15FP □ / NDP-15FVT ・ ・ ・ Flat valve ★ The flat valve type cannot handle slurry.
★ The initial self-priming lift is 1m for all models.

 

The maximum operating pressure of the body wetted part resin type (FP □ / FVT) is It depends on the liquid temperature. Be sure to check the liquid temperature-maximum working pressure diagram.